We have passed on the trailer as the owner is asking for top billing without the furniture and having painted the inside. I was quoted by a local GD dealer the replacement value would be in the ballpark of around $3,500-$4,000 for both. But if your table is not exactly what you like, figure out what would work better for you, make a full-sized pattern, and have a custom top made.Cate&Rob Awesome, thanks for the information. We’re pleased with the size and shape of the egg-shaped front table, so we see no reason to change that smaller table. We have used the table for several years now and are very happy with the changes we made.
![rv dinette replacement rv dinette replacement](https://harvesthosts.com/wp-content/uploads/2019/08/9-e1564942776484.jpg)
Roger made a cup holder out of a piece of oak that keeps things from sliding around when moving. The new table stops about 1.5 inches short of the door, so we gained back any space we lost by the rounding of the front corners and gained some more. The base was moved from the old table to the new table. The shop had even added white laminate on the bottom of the table to hide the plywood. A few days later we picked it up – cost about $60. We picked a light gray speckled granite look. They said we would have more trouble keeping it looking nice. Lynn had wanted white since we had white Corian on the counter, but the shop advised against pure white. We could have ordered something, but we found a color we liked. We took the plywood to the countertop shop and picked out a laminate from his extras pile. We got a “no knots – two good sides” piece of the right thickness big enough to cut the table from. We went to the premium lumberyard in town to get good plywood in the right thickness. He measured the thickness of plywood we would need. Too heavy and not structural for bed support. Most countertops have particle board underneath. The guy looked it over and said sure he could do it, but he didn’t stock plywood for countertops. We took the existing table and the pattern to a local countertop shop. We used the radius of part of the egg-shaped table in the front. We made a pattern on cardboard for rounding the ends. The height was important also, but the length could vary quite a bit. The width was critical since it made up part of the bed. We examined the original table made of sturdy plywood with a laminate top. We decided that rounding the front corners and extending the length closer to the door would be ideal. So we figured a few minor changes to the table would make it perfect.
#Rv dinette replacement plus#
Plus getting in and out of the dinette was a bit tight – more clearance between the table and the cabinets would be nice. We never used the cup holders with the table in place.
![rv dinette replacement rv dinette replacement](https://lifewithnealandsuz.com/wp-content/uploads/2020/08/IMG_9772-768x1024.jpg)
![rv dinette replacement rv dinette replacement](https://placeofmytaste.com/wp-content/uploads/2021/02/DIY-Dining-Table-for-an-RV-9-of-12-768x1024.jpg)
We assume this was so the cup holders mounted to the rear door could be used. Since our aisle extends all the way to the rear door this seemed like a loss of useful workspace. The table stopped about 7.5 inches short of the rear door. New RV table top on left extends 6 inches further to the rear.īut the dinette was not quite perfect. All of them (so far) were impressed with the spaciousness of the dinette – many Class B’s can only seat two people at the table. We have always enjoyed meeting other Class B owners in campgrounds and inviting them over for coffee and ice cream after dinner. However, our Roadtrek easily seats four adults at the main table (and three at the front table if needed). And that’s average-sized adults! The two on the end are still overhanging the aisle by half a cheek. Our friend’s 37-foot Class A motorhome can barely seat four people at the table of the RV. One of the things we love about our Roadtrek is the large dinette.